Holly's Whipholders

(No, I didn't make these. I wish I were that talented. Anyone wanna teach me how?)

Going left to right: LC prototype, shorter one with male snap on the loop (LC?), TOD (female on the loop):

~rontholderall3.jpg (11853 bytes)    ~ackholderall3.jpg (12081 bytes)   ~ideholderall3.jpg (15842 bytes)

On the view of the back side (middle pic), I tried to lighten enough and use more contrast on the the adjustments so you could see the prototype stitching better.

The TOD holder has a length of 9 inches and a width of 1 and 3/8 inches.

The other holder (LC?) has a length of 9 and 1/4 inches and a width of 1 and 3/8 inches.

 

More About the Prototype

The guy who made these whipholders said this about his prototype (long holder) (pics below):

"By enclosing the snap in stitching, I can prevent the weight of the whip from distorting the belt-loop downward."

The prototype's length is 10.5 inches, with the width being 1 and 3/8 inches.

 

The Prototype Upclose (front, inside, back):

~rontprototype.jpg (4188 bytes)      ~nsideprototype1.jpg (3807 bytes)      ~ackprototype.jpg (5322 bytes)   

 

Back Home