Notes:
 
11-09-05

Again short of time so I only managed to install the Galley Trim Edging. The plans called for a 2 piece section made up of 1/2" aluminum angle and another ripped 1/2 angle on the inside to form a U channel. I located 1/2" U channel locally and used it instead. This saved time and eliminated a failure point.

I worried that the U channel would buckle when formed to the galley side but the section formed perfectly around the bend. #8 x 1/2" stainless steel screws were used to secure, and polyurethane caulk to insure a water tight seal.
 
Installed the Galley Trim Edging