Notes:
 
10-28-05

Here is a picture of all the hardware yet to be installed on the door.

Note the small oval plate near the T handle . I fabricated it so I would not have to cut into the T molding. More on that later. I also made the 1/8" plate near the latch to raise the inside latch for a better fit. The insulation at the top of the picture goes on the T molding, fitting it large side out (opposite of the directions). The Frost King weather strip was used in the door jam area. The stainless clamshell covers are used for door vents. More on that later.
 
Finishing Up the Door