Just about every body lifts the airplane ( during inspections) with the Landing gear clamps. This forces the gear legs up into the gear box and makes them "Look good" It is really important to lift the airplane itself at least seven inches( so that the gear is hanging FREE ) and then SHAKE the heck out of it ) I use a R182 jack pad that fits the 170 like Cessna meant it to be !! Drill out the appropriate rivets and replace them with 10-32 screws, stronger then the rivets or "as good as or better" I installed nut plates cause I do this all the time, but there is easy access through the Strut inspection holes. Use these screws to hold the jack pad in place and after you take the pads off , be sure and replace the screws. A lot safer to lift with , even for changing a tire. I keep the pads in the pocket behind my seat.  

Also , we have been chatting about Scott tail Wheels, (which can go on for ever ) BUT be very careful about using compression type Tail Wheel steering springs. When the spring coils close the spring becomes a solid link. And you can generate a TON of pressure on the rudder cables and steering cables on the late B models.   Some thing is gonna give!! With the heavy duty steering arms we are using , it may not be the arm that bends. It may pull the lower pulley arm attach points out of the bulkhead ( I have had three airplanes do this and it is an awful lot of work. Incidently, we have developed a doubler that repairs this bulkhead.

If you want to chat about C170B drop me a line