To receive a quote or additional information on Howell Electronic Services
Design, Fabrication, or Assembly, please fill out the form below.
This document
is intended to be used by Howell Electronic Services as a tool to provide
the customer with the highest quality PCB design and documentation of their
PCB. Please take a minute and fill out as much of the document as is applicable.
If a line is not applicable, please write “N/A”.
1. General Information:
First Name: *
* = Required fields
Last Name: *
Company Name:
Address Line 1:
Address Line 2:
City:
State:
Zip Code:
Country:
Phone: *
Fax:
E-mail: *
Job Function
Other:
Boards/year
2. Timeline to Start of Project:
3. Required Time To Finish Board (Turn Time)
4. PCB Design Information:
Schematic Diagram:
and Netlist
None/To Be Developed
On Paper/To Be Entered
Input into
EDA package
Netlist Available in
Format
Board mounting holes connected to ground
Connector Mounting Locations Defined
Connector mounting holes connected to ground
Trace and component keep-out areas defined
Plane Splits (power/signal) defined
Placement
Pre-placement sketch
Special requirements for placement such as height, thermal,
spacing, clock length
Allow components on both sides?
Permit addition/deletion
of decoupling caps
How should the decoupling capacitors be placed?
Which components require sockets:
Routing
Are source and termination resistors defined in the schematic?
Do you have a list of your critical nets? Y/N
Describe any special concerns for critical nets:
What is your desired Layer Stack-up?
4. What is the desired Via size? ________ hole ________ pad
5. What are the minimal trace size and spacing?
Net Type: _____________ Size __________________
via to via ______________ via to pad ______________ via to
signal _____________
signal to signal _________ signal to pad _____________
pad to pad ______________ copper pour clearances
Net Type: _____________ Size __________________
via to via ______________ via to pad ______________ via to
signal _____________
signal to signal _________ signal to pad _____________
pad to pad ______________ copper pour clearances
Net Type: _____________ Size __________________
via to via ______________ via to pad ______________ via to
signal _____________
signal to signal _________ signal to pad _____________
pad to pad ______________ copper pour clearances
6. Are there any special clearance requirements? Y/N
Panelization and Test
Is a Panel Drawing Required? Y/N
Do you require the Gerber data in Panelized format? Y/N
Do you require a test point on every signal? Y/N
What size and spacing is required for the test points?
Deliverables:
How do you want to receive deliverables?
Compact disk
(please delivery method)
E-mail
Other
Please check off the required deliverables:
Gerber Data (list types)
Drill Data
Database
Fabrication Drawing (DXF, other)
Assembly Drawing (DXF, other)
Panel Drawing
Was-Is file on disk.
Can you provide sample drawings of your Fab and Assy? Y/N
Do you have your company formats on DXF or other CAD Database?
Y/N
Do you have a preferred set of Fabrication Drawing Notes? Y/N
5. Please let us know how you came to Howell Electronic Services
website. (Please select one RADIO button and one item from
the corresponding list on the right.)
Postcard
E-mail
Referral
Web Search Engine
Web Link
Seminar
Technical Article
Newspaper Article
Magazine Ad
Trade show
6. Check any or all of the following if you would like more information
about Howell Electronic Services
board layout, fabrication, manufacturing, assembly services or testing.