Aileron Torque tube is in

Drilling for snap bushings. The larger electrical conduit was a real pain

Aileron Pushrod is attached to bell crank, checking for fit

All of the Pitot and AOA tubing is pulled and in place, including the right wing - not shown

Flaps & Ailerons are polished and on - also aligned

The aileron trim is assembled and the push tube is marked for mounting

Aileron push tube attached to bell crank

pitot and AOA tubing is pulled

Checking the aileron torque tubes for proper clocking

Checking everything for fit, Pitot, aileron bell crank, and a place for the pitot heater control

The Left Aileron is on to check for fit

Another shot of the polished ailerons and flaps mounted

Aileron trim motor hooked up and installed, starting wiring with D-sub pins & sockets