OTHER 12 VOLT CONVERSIONSThese are just two examples of some other ways of converting the Ford 8N Tractor electrical system. There are literally hundreds of ways that half work or don't work at all. Both of these examples use the original or a rewound GENERATOR instead of an alternator. You give up performance since an alternator puts out a lot more current, especially at low RPM. But the generator looks more original, is weatherproof, and is just a far more durable and forgiving part.OTHER ALTERNATIVESAn often overlooked upgrade that might be more appropriate for these tractors is an upgrade to 8 volts or even 12 volts using the original generator or one rewired for 12 volts. Both of these upgrades are ideal for many show tractors or restorations. You can leave the standard wiring exactly like original and the installation LOOKS original! If you use either of these suggestions, please make sure the regulator, battery and generator are clearly labeled with the new voltage and polarity if you change it! DETAILS The 8 volt Conversion - It is possible to simply install an 8 volt battery and readjust the voltage regulator to put out around 9.3 volts in order to properly charge the 8 volt battery. This requires someone with the equipment, knowledge, and ability to properly adjust the voltage regulator. Obviously the 6 volt light bulbs will be brighter and they probably won't last as long. You should also add some additional resistance in the ignition circuit to protect the coil. Please refer to my comments on the main 12 Volt page regarding coils and ignition resistance. The 12 volt Conversion - For this one you need to find a shop that will re-wind your generator to put out 14 volts. Then you can use a standard, off-the-shelf 12 volt regulator, 12 volt coil, and 12 volt bulbs. |